- The complete Power-Vac is weather sealed around- clean out doors, door frames, inside the compartments, all butted edges, and anywhere water can start rusting the POWER-VAC.
- The under carriage is painted with a rust inhibitor paint and all seams are under-sealed.
- The compartments are entirely enclosed, to keep dust and water out, & prevent equipment loss.
- Drip rails are over all doors, keeping water out of the tool compartments.
- The vertically hinged side compartment doors are out of the way while in the open position.
- Side pipe & hose enclosure doors are standard equipment.
- DEPENDABLE trouble free two piece drive line.
- The fan housing scroll is lined with a ware resistant 1/8” Stainless Steel Liner extending serviceable life.
- The air compressor is geared to obtain approximately 85% of its capacity at normal RPM.
- Flush tail & backup lights.
Formed steel fenders have splash guards behind them to keep the mud and water off of the skirts and out of the hose and pipe rack.
- There are drain spouts in the pipe and hose enclosure for washing it out.
- There is a side compartment access door to the compressor air-filter & dipstick for servicing.
- The oil pressure gauge for the compressor is visible in the side compartment for monitoring.
- Grease zerks for the fan shaft and grease seal are on the exterior surface for easy access.
- Brackets are standard for mounting a shelf over the pipe and hose enclosure.
|
- The back enclosure door is made of aluminum and has one latch for one-hand operation, as does the rear compartment door.
- The intake elbow is made of steel & swivels right to left, 230 degrees.
- The fan speed is controlled with a micro locking throttle for exact engine and fan RPM.
- We use a 41" closed face fan, which equals 30-35% more air at the same RPM than an open faced fan.
- Stainless steel locks with matching keys.
The drive train on the compressor and fan is matched to the transmission (Power-take-off) gear ratio. The engine RPM is ideal for maximum fuel economy and extended engine and drive train life, while maintaining maximum vacuum. (VERY IMPORTANT for your bottom line).
- Tip up ladder Rack.
- Air Deflector ( keeps the bags from blowing about while in transit).
- Four air supply locations. (couplers).
- Rubber inlay is installed on the ladder steps.
- Parts are normally interchangeable with all look a like units.
- ALL work, manufacturing, assembly and quality control are performed or supervised by the OWNERS to assure your satisfaction and confidence in our products.
- Most parts are in stock for same day shipment.
- WE (DAVE & HAROLD) TAKE PRIDE in every unit that leaves the plant.
- On the Job Training, Furnace & Duct Cleaning, POWER-VAC maintenance & operation, training materials & ideas to support your advertising are part of every POWER-VAC sale.
|
